
2YM15
2YM15
2YM15-22 Marine Installation Manual - Volume 2
© 2007 Yanmar Marine International
Cold Starting Aids
The 2YM15 engine is not equipped with cold
starting aids.
Air Venting
The 2YM15 uses either a KM2P-1 marine gear or a
SD20 sail drive, no venting device is needed.
Water Heater Tank Connection
The 2YM15 engine supports water heating tank
connections for onboard head and galley operation.
Figure - 22
Optional Accessories
The following is a list of the 2YM15 optional
accessories.
• New B-type (VDO) panel
• New extension wire harness (EWN3)
• Battery switch (BS500)
• Side-mount single control head (MORSE: MV)
• Top-mount single control head (MORSE: MT3)
• Push-pull control cable (MORSE: 33C) (RC4,
RC7)
• Propeller shaft half coupling, slit (CSG1)
• Propeller shaft half coupling, taper (CTG1,
CTG2, CTG3, CTG4)
• Propeller shaft half coupling, straight (CRG1)
• Lube oil evacuation pump (EPP1)
• Electric type bilge pump, 12 V (BP1)
• Seacock (K1, K2)
• Fuel tank 30 L (8 gal) (FT1)
• Alternator, 12 V - 80A
• U-type, water mixing elbow
0002781
(1)
(2)
1. Water to Tank 2. Water from Tank
JUN 2006 (Rev. 1)
Kommentare zu diesen Handbüchern