Yanmar 1GM10C Spezifikationen PDF herunterladen (Seite 51)

6. Pump the oil into the drive. After the first

bottle is empty, screw in the oil changing

plug.

7. Change the bottle while the pump and

hose remain connected to the adapter

joint.

8. After filling, first screw in and tighten the

plug at the top cover. Then remove the

oil bottle, pump, hose and adapter joint

and screw in the oil drain plug.

Using Yanmar Hand Pump

Refer to Preparing The Sail-Drive on page

45.

0005460

(1)

Figure 13

1 – Plug

1. Connect the hose from the bottom and

a suction hose to the Yanmar pump with

hose clip (Figure 13).

2. Take out the plug from the upper case

cover (Figure 13, (1)).

3. Pump the oil into the drive. Be aware

that oil has to flow up through restricted

parts of the drive, so pumping will be

hard. Waiting a few minutes will help.

After pumping in about 1 L (1.1 qt) of oil,

screw in the oil changing plug. Be aware

that the drain hose can easily slip out of

the bucket and cause oil spilling. The

hand pump and rubber hose are

available from Yanmar, and are optional

parts for SD50 / SD50-4T. Any type of

hand pump or rubber hose of inner

diameter 14 to 16 mm (0.5 to 0.625 in.)

available locally can be used.

0005461

Figure 14

4. After filling, first screw in and tighten the

plug at the top cover. Then remove the

pump, hose and adapter joint and screw

in the oil drain plug.

By not using pump

Refer to Filling With Lubricating Oil - SD20,

SD50 and SD50-4T on page 19.

PERIODIC MAINTENANCE

SD Operation Manual 47

© 2009 Yanmar Marine International

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare