Yanmar 1GM10V Spezifikationen PDF herunterladen (Seite 20)

3. Operation

20

3.2.4 Cranking

When the engine has not been used for a

long period of time, lube oil will not be

distributed to all of the operating parts.

Using the engine in this condition will lead

to seizure.

After a long period of disuse, distribute

lube oil to each part by cranking. Perform

in accordance with the following

procedures

before beginning operation.

1. Open Kingston cock.

2. Open fuel tank cock.

3. Put remote control lever in NEUTRAL.

Manual Operation

4. Pull out decompression lever.

5. Put starting handle on the starting

shaft, and turn about 10 times. Check

for abnormal noise while cranking.

002557-00E

Ԙ Forward ԙ Neutral Ԛ Reverse

Ԛ

ԙ

Ԙ

Decomp. lever

Decompression

Drive

002549-00E

Electric Operation

4. Turn on battery switch and insert key

into key switch. Turn the key to the

ON position.

5. Pul the stop knob continuously while

cranking.

6. When the start button is pushed, the

engine will begin cranking. Continue

cranking for about 5 seconds, and

check for abnormal noise during that

time. (If you remove your hand from

the stop knob while cranking, the

engine will start. Pull continuously.)

3.2.5 Check and Resupply Lube Oil

When engine oil or clutch oil is supplied

for the first time or when they must be

replaced, conduct a trial operation of the

engine for about 5 minutes and check the

quantity of lube oil. The trial engine

operation will send the lube oil to the

parts, so the lube oil level will drop.

Check and resupply as necessary.

1. Supplying engine lube oil (See 3.2.2)

2. Supplying marine gear lube oil

(See 3.2.3)

002558-00E

Manual

start

position

GM OPERATION.book 20 ページ２００４年１０月４日　月曜日　午前１１時１１分

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare