Yanmar ZT370 Spezifikationen PDF herunterladen (Seite 30)

STERN-DRIVE OPERATION

26 ZT370 Operation Manual

Check the Stern-Drive Oil Level

*1: Quick Silver is a registered trademark of

Brunswick Corporation.

Note: The oil level will rise and fall during

operation. Check the oil level before

starting, when the engine is cold.

1. Check the stern-drive oil level

(Figure 2). Keep the oil level at or near

the OPERATING RANGE (full) line

(3, Figure 2) on the oil reservoir

(1, Figure 2).

2. The oil level is low if it is below the ADD

line (2, Figure 2) on the oil reservoir

(1, Figure 2). Fill as needed with the

specified oil. See Fill the stern-drive

with oil on page 26.

Figure 2

NOTICE

If any water is visible at the bottom of the

oil reservoir or appears at the oil fill/drain

plug and/or if oil appears discolored,

consult your authorized Yanmar Marine

dealer or distributor immediately. Both

conditions may indicate a water leak

somewhere in the stern-drive.

■ Fill the stern-drive with oil

See Changing the stern-drive oil on

page 36 when filling the entire stern-drive.

NOTICE

If more than 60 ml (2 fl oz) of gear oil is

required to fill the reservoir, a seal may be

leaking. Damage to the stern-drive may

occur because of lack of lubrication.

Consult your authorized Yanmar Marine

dealer or distributor.

1. Remove the oil reservoir cap

(1, Figure 3).

2. Fill the oil reservoir to the OPERATING

RANGE (2, Figure 3) (full) line with

specified fluid.

NOTICE

Do not overfill.

Description Where used

BY3

series

Quick Silver

®*1

High Performance

Gear Lube or

GL-5 (SAE 80W90)

Oil reservoir

6LPA

series

8LV

series

Quick Silver

®*1

High Performance

Gear Lube

039050-00X00

2

3

1

ZT370_OM.book 26 ページ２０１３年９月２７日　金曜日　午前１０時１６分

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Kommentare zu diesen Handbüchern

Aurelio 29 Oct 2024 | 18:29:11

Necesito manual de reparación completo por favor.