Yanmar BY series Spezifikationen PDF herunterladen (Seite 68)

ENGINE OPERATION

BY Series Operation Manual 61

SHUTTING DOWN THE

ENGINE

Under normal operating conditions, shut

down the engine by turning the key switch

to OFF.

There may be a delay of up to 3-seconds

after turning the key to OFF. This is normal

and allows the ECU computer to store

data.

Emergency Shut Down

1. Ensure lanyard is connected to the

emergency stop switch.

2. Attach the lanyard to a secure place on

the operator’s clothing or life vest - not

where it might tear away.

IMPORTANT

Do not cut or re-tie the lanyard. If it

is too long, shorten it by knotting

or looping it.

Test the emergency engine shut

off switch before each outing.

3. Disconnecting the clip from the stop

switch will stop the engine.

CHECKING THE ENGINE

AFTER OPERATION

• Check that the key switch is in the OFF

position and battery master switch (if

equipped) is OFF.

• Fill the fuel tank. Make sure that the fill

cap and the area around the fill opening

are clean to avoid contamination of the

fuel.

• Close seawater cock(s).

• If there is a risk of freezing, check that

the cooling system contains enough

coolant. See Engine Coolant on

page 49.

• If there is a risk of freezing, drain the

seawater system. See Drain Seawater

Cooling System on page 108.

CAUTION

Be sure to close the seacock.

Neglecting to close the seacock

could allow water to leak into the

boat and may cause it to sink.

0000152en

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 126 127

Kommentare zu diesen Handbüchern

Keine Kommentare