Yanmar 1GM10V Spezifikationen PDF herunterladen (Seite 33)

5. Slide the starter handle

(Figure 8, (2)) on the starter shaft

(Figure 8, (1)), align the groove and

pin, and turn the engine over about 10

times.

(1)

(2)

0005888

Figure 8

1 – Starter Shaft

2 – Starter Handle

6. Listen for any abnormal noises while

cranking the engine.

7. Remove the starter handle.

8. Place the decompression lever in the

RUN position.

CRANKING THE ENGINE

ELECTRICALLY

NOTICE: When performing engine

break-in or if the engine has not been

used for a long period of time, engine oil

will not be distributed to all of the

operating parts. Using the engine in this

condition will lead to seizure.

After a long period of non-use, distribute

engine oil to each part by cranking the

engine. Perform the following procedure

before beginning operation:

1. Open the seacock.

2. Open the fuel cock.

Note: If the engine has not been

operated for a long period of time,

check that the key can be moved

from the OFF to the ON position

smoothly.

3. Put the remote control shift lever in the

NEUTRAL position.

4. Pull the engine stop knob

(Figure 9, (1)) out and hold

continuously while cranking.

(3)

(1)

(2)

0005842

Figure 9

1 – Engine Stop Knob

2 – Bulkhead

3 – Engine Stop Cable

5. With the key in the ON position, push

the start button and the engine will

begin cranking.

6. Continue cranking for about 5 seconds

and listen for any unusual noises.

BEFORE YOU OPERATE

GM Series Operation Manual 27

© 2007 Yanmar Marine International

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare