Yanmar 1GM10V Spezifikationen PDF herunterladen (Seite 38)

NOTICE

If any indicator illuminates during engine

operation, stop the engine immediately.

Determine the cause and repair the problem

before you continue to operate the engine.

If the alarm indicator lamps and audible

alarm fail to display or sound when the

ignition switch is in the ON position, see your

authorized Yanmar Marine dealer or

distributor for service before operating the

engine.

Observe the following environmental

operating conditions to maintain engine

performance and avoid premature engine

wear:

• Avoid operating in extremely dusty

conditions.

• Avoid operating in the presence of

chemical gases or fumes.

• NEVER run the engine if the ambient

temperature is above +40˚C (+104˚F) or

below -16˚C (+5˚F).

• If the ambient temperature exceeds

+40˚C (+104˚F), the engine may overheat

and cause the engine oil to break down.

• If the ambient temperature is below -16˚C

(+5˚F), rubber components such as

gaskets and seals will harden causing

premature engine wear and damage.

• Contact your authorized Yanmar Marine

engine dealer or distributor if the engine

will be operated outside of this standard

temperature range.

NEVER engage the starter motor while the

engine is running. Damage to the starter

motor pinion and / or ring gear will result.

STARTING THE ENGINE

ELECTRICALLY

NOTICE: If the vessel is equipped with a

water lift (water lock) muffler, excessive

cranking could cause seawater to enter

the cylinders and damage the engine. If

the engine does not start after cranking

for 10 seconds, close the thru-hull water

intake valve to avoid filling the muffler

with water. Crank for 10 seconds or until

the engine starts. When the engine does

start, stop the engine immediately and

turn the switch to the OFF position.

1. Open the seacock (if equipped).

2. Open the fuel cock.

3. Put the remote control shift lever in the

NEUTRAL position (Figure 1, (1)).

Note: Safety equipment should

make it impossible to start the

engine in any position other than

NEUTRAL.

(1)

0005890

Figure 1

1 – NEUTRAL (N)

4. Turn the master battery switch (if

equipped) to ON.

ENGINE OPERATION

32 GM Series Operation Manual

© 2007 Yanmar Marine International

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare