Yanmar 6LPA-STP2 Spezifikationen PDF herunterladen (Seite 29)

100

101

When the engine is being used for the first time or if it has not been used for a long period of time,

perform cranking before starting to distribute oil to all of the parts. Using an engine which has

been stored for a long period of time without the cranking procedure may result in engine seizure,

since there will no longer be oil on the moving parts after storage.

①Open Kingston cock. (Optional)

②Open the fuel tank valve.

③Put marine drive in NEUTRAL

④Turn the battery switch on.

⑤Crank the engine.

Push the stop button to stop fuel ignition

while cranking.

1) Put the key into the starter switch.

2)Turn the key to the ON position.

The alarm buzzer should sound and

alarm lamps come on. This is normal

(see 2.5.1

(

)

3) While pushing the stop button, turn the

key to the START position and hold it

there. The engine will begin turning.

If you remove your hand from the stop

button, the engine will start. Do not take

your hand off the button.

⑥Continue cranking the engine for about 5 seconds, checking for abnormal sounds.

⑦Return the key to the OFF position. The engine will stop.

⑤Remove the subtank cap and fill with water

to the maximum limit, FULL. Replace cap.

Subtank capacity : 1.6

⑥Check the rubber hose connecting the

subtank to the fresh water tank. Be sure the

hose is securely connected and there is no

looseness or damage. When the hose is

not watertight, an excessive amount of cool-

ing water will be consumed.

Rubber hose

Clamp

Filler cap

To Fresh water tank

FULL:

Max.limit

LOW:

Min. limit

3.6 Cranking

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 698 699

Kommentare zu diesen Handbüchern

Keine Kommentare

Yanmar 6LPA-STP2 Spezifikationen Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Yanmar 6LPA-STP2